Installing an air ride suspension system in a automotive is an effective way to customize a automobile in order that it might easily assist changing load demands. air ride suspension system are better to choose than regular air shocks these aren’t designed to hold any extra load. Their primary purpose is to dampen the suspension system only.
Note : Teflon tape or Teflon sealant can be used to make sure there are no leaks in the threads. If welding is required and if you don’t have the equipment to do it, take whatever you need welded (usually axle housing) to a job shop. It’ll rarely take more than 10 minutes for the staff to do the job for you. Avoid the heat from the exhaust system and moving parts when routing lines to the spring.
Air Ride Suspension Systems Installation Procedures
1. Decide if you wish to change both the entrance and rear suspension methods by putting in an air ride suspension system in your automotive, or if you wish to only replace the back.
2. Remove completely the old suspension. You will discover directions on how to do that within the car’s owner manual. You may throw away or recycle all the unique components.
3. Set up the upper half of the meeting and the decrease portion of the air spring support. Install the air becoming, then you will get to work attaching the entrance air springs. Tighten the nuts that include the equipment to secure the cross shaft to the higher management arm.
4. Repeat Steps 2 and 3 for the opposite wheels. You will need to do that for 3 extra wheels if you happen you’re changing the back and front suspension system, or for another wheel if you’re only putting in a rear air ride suspension system in your car.
